HP LF Printing Knowledge Center Calibrate your monitor Printer: HP Designjet Z2100/Z3100 series Software: HP Advanced Profiling Solution OS: Mac OS X
The display is your only reliable way to view your digital files before you print them. Since all displays change over time, calibration is necessary to bring these devices back into a consistent and repeatable display condition. The role of the calibration is to adjust the device to produce a desired behavior. Once the display is calibrated, an ICC device profile will be built to record this device behavior. You should calibrate and profile your display on a regular basis, at least once a month.
Step 2: You can use the HP Advanced Profiling Solution to calibrate and build ICC profiles for all your displays. From this screen you can select which device, a monitor or printer you wish to calibrate and profile. You should calibrate and profile your display first. • If you are now ready to calibrate and profile your display, click on the Monitor button. • Select the Next button to continue with the next step.
Step 3: Display type and Measurement Device Selection. NOTE Please allow your display to warm up and stabilize before you calibrate. Allow 30-45 minutes for a CRT and 10-15 minutes for a LCD. • Select the display type to calibrate and profile. It is important that you select the correct type of display before proceeding. • The Expert Options allow you to override the default calibration target values and will take you to a screen where you can set custom calibration target values.
Step 4: Monitor Profiling: OSD Controls. • Select the OSD (On-Screen Display) control capabilities of your monitor in order to achieve optimum results. o If your display provides a Brightness control, please activate the Brightness check box. o If your display provides a Contrast control, activate the Contrast check box. o If your display provides RGB controls, activate the RGB check box.
Step 5: Eye-One Display on your monitor. • Place the Eye-One Display on the screen. The Eye-One can be placed anywhere on the screen as the software automatically detects the Eye-One's position. Attempt to place the instrument in the center of the screen and in such a way that it will not allow any ambient light to enter between the instrument and the surface of the display. • Select the Next button to continue with the next step.
Step 6: Create Monitor Profile (White Point, Gamma and Luminance). • • • Calibrate Contrast: o Set the contrast of your display to its maximum value using your monitor controls. o Adjust the contrast on your display until the orange line is placed in the middle of the green area. o Click the Next button to continue with the next step. Calibrate Brightness: o Adjust the brightness on your display until the orange line is placed in the middle of the green area.
values are cooler (more blue). 6500K is recommended for CRT displays while Native White Point is recommended for LCD displays. The Luminance setting defines the maximum intensity (brightness) of white measured in cd/m2. Select a value based on display type and the amount of ambient light around the display. A recommended starting point is 90 CRTs and 120 for LCDs. • If you wish to use the current luminance the display is producing, select Native.
Step 7: Calculate ICC Profile and finish.
For more information on HP Designjet products www.hp.com/go/designjet © 2007 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
