HP Designjet Z3100 Printing Guide [EFI Designer Edition RIP] - Calibrate my printer [Windows]

ManualsBrandsHP ManualsPrinterHP Designjet Z3100 44-in Photo Printer

HP LF Printing Knowledge Center

Calibrate my printer

Printer: HP Designjet Z2100/Z3100 series

Software: EFI Designer Edition for HP

Operating System: Windows

Summary of content (5 pages)

PAGE 1
HP LF Printing Knowledge Center Calibrate my printer Printer: HP Designjet Z2100/Z3100 series Software: EFI Designer Edition for HP Operating System: Windows
PAGE 2
The color calibration must be performed whenever: • A printhead is changed. • A new combination of paper type and print mode is loaded which has not been previously calibrated with the current set of printheads. • The environmental conditions change (for example, temperature or humidity). • You notice deterioration in the quality of your prints or large quantities of plots have been printed since the last calibration.
PAGE 3
. A calibration test chart is printed, which contains patches of each ink used in your printer. The printer will print and measure this linearization target and calculate the necessary correction factors to apply for consistent color printing on the paper type. It also calculates the maximum amount of each ink that can be applied to the paper.
PAGE 4
The color calibration is complete. You can check if your media type and print mode have already been calibrated under Preferences > Printer > Calibration.
PAGE 5
For more information on HP Designjet products www.hp.com/go/designjet © 2007 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.