HP LF Printing Knowledge Center Calibrate my printer Printer: HP Designjet Z3100 series Software: HP raster driver Operating System: Windows
The color calibration must be performed whenever: • A printhead is changed • There is a new combination of paper type loaded and print mode selected and has not been previously calibrated with the current set of printheads. • The environmental conditions change (for example, temperature or humidity) • You notice deterioration in the quality of your prints or a high amount of printing has been done since the last calibration.
4. You will see calibration information for various paper types. • Paper Name: Select the media that is loaded on the printer and that you want to calibrate.
5. Select Next. 6. A calibration test chart is printed, which contains patches of each ink used in your printer. The printer will print and measure this linearization target and calculate the necessary correction factors to apply for consistent color printing on the paper type. It also calculates the maximum amount of each ink that can be applied to the paper.
7. Once the printer calibration is complete, select Done.
For more information on HP Designjet products www.hp.com/go/designjet © 2005 Hewlett-Packard Development Company, L.P. The information contained herein is subject to change without notice. The only warranties for HP products and services are set forth in the express warranty statements accompanying such products and services. Nothing herein should be construed as constituting an additional warranty. HP shall not be liable for technical or editorial errors or omissions contained herein.
