HP ProLiant DL100 G2 Data Protection Storage Server administration guide (June 2006)

Table 5 Commonality between DL100 G 2 Da ta Protection Storage Ser ver configurations
Feature Item
Server family
ProLiantDL100G2StorageServer
Processor
IntelPentiumD2.8GHz,dualcore,800MHzFSB,2MBL2cache
Memory (ECC PC2
–4200 DDR)
1GB(2x512MB)
Chip set
Intel Mukilteo memory c ontroller, Intel ICH7R I/O controller, Intel PXH-V
PCI
Expansion slots (2 total)
One PCI-X 64-bit 133-MHz standard height, full-length
One PCI-X 64-bit 133-MHz low-profile, half-length
Hot plug cage
SA T A
Hot plug back panel
Yes
Power supply (single, NHP)
350 Watts
DVD-ROM (8X)
Yes
1.44 floppy disk drive
No
Fans (11 total) Two in power supply
Nine in chassis
NIC (embedd
ed)
Two total: o
ne BCM 575 1 and one 572 1
SCSI (tape connection)
PCI-X add-in card option
Server connections
Four USB ports (2 front, 2 rear)
One PS2 keyboard
One PS2 mouse
One serial port
Server ma
nagement
IPMI 2.0
Operating system
Windows Storage Server 2003 R2 Standard Edition
Chassis 1U rack
Rail kit i
ncluded
Yes
Factory image
The DL100 G2 ProLiant Data Protection Storage Ser vers are set up at the factory with lo gical drives for
the operating system and user data. No additional storage configu ration is needed.
Physic
al configuration
Depend
ing on the model, each storage ser ver com es with either two or four internal Serial Advanced
Technology At tachment (SATA) hard disk drives (HDDs). The sections below describe how these internal
HDDs are configured for each storage ser ver based on whether t wo or four HD D s a re installed.
Two-HDD configurations
The t wo H DDs used with the 3 TB and 6 TB D ata Protection Storage Servers are configured for software
RAID fault tolerance using the motherboard SATA controllers.
The HD Ds for the DL100 G2 are hot-pluggable, but not hot-swappable. The drives can be removed or
inserted while the power is on, but user intervention is neede d to rebuild the arrays.
26
Storage server specifications and image configurations