HP ProLiant DL100 G2 Data Protection Storage Server administration guide (June 2006)

Figure 40 Slid ing HDD from bay
4. Remove the four screws securing the HD D to the H DD tray.
Figure 41 Removing HDD from tray
Reverse the steps to install a new HDD.
RA ID controller card
CAUTI
ON:
Remove
power to the server by disconnecting the power cord before removing or installing a RAID
controller card and riser assembly.
1. On the RAID controller card, disconnect the hard drive cables that connect to the SATA ba ckplane,
and the HDD activity cable that connects to the system board.
2. Lift the riser card assembly out of the chassis. (The RAID c ontroller c ard is connected the riser
card assembly.)
54
Troubleshooting, servicing, and maintenan ce