HP ProLiant DL100 G2 Data Protection Storage Server administration guide (June 2006)

For more information about battery replacement or proper disposal, contact an authorized reseller or a n
authorized service provider.
Taiwan battery
recycling notice
The Taiwan EPA requires dry battery manufacturing or impor ting firms in accordance with
Article 15 of the Waste Disposal Act to indicate the recovery marks on the batteries used in sales,
giveaway or promotion. Contact a qualified Taiwanese recycler for proper battery disposal.
Power cords
The power cord set must meet the requirements for use in the country where the product was purchased.
If the product is to be used in another countr y, purchase a p ower cord that i s approved for use in
that country.
The power cord must be rated for the product and for the voltage and current marked on the product
electrical rating label. The voltage and current rating of the cord shou ld be greater than the voltage and
current rating marked on the p roduct. In addition, the diameter of the wire must be a minimum of 1.00
mm
2
or 18 AWG, and the length of the cord must be between 1.8 m (6 ft) and 3.6 m (12 ft). If you have
questions about the t ype of power cord to use, contact an HP authorized service provider.
NOTE:
Route power cords so that they will not be walked on and cannot be pinched by items placed upon
or against them. Pay particular attention to the plug, electrical outlet, and the point where the cords
exit from the product.
Japanese power cord notice
Electrostatic discharge
To prevent damage to the system, be aware of the precautions you n e ed to follow when setting up the
system or handling parts. A discharge of static electricity from a fing er or other c onductor m ay damage
system boards or other static-sensitive devices. This type of damage may reduce the life expectancy of
the device.
Preventing electrostatic discharge
To prevent electrostatic damage, observe the following precautions:
• Avoid hand contact by transporting and storing products in static-safe containers.
• Keep electrostatic-sensitive par ts in their conta iners until they arrive at static-free workstations.
• Place par ts on a grounded sur face before removing them from their containers.
• Avoid touching pins, leads, or circuitry.
• Always be properly grounded when touching a static-sensitive component or assembly.
Grounding methods
There are several methods for grounding. Use one or more of the following method s when handling or
installing electrostatic-sensitive parts:
• Use a wrist strap connected by a ground c ord to a grounded workstation or computer chassis.
Wrist straps are flexible straps with a minimum of 1 meg ohm ± 10 percent resistance in the
ground cords. To provide proper grounding, wear the strap snug against the skin.
HP ProLiant DL100 G2 Data Protection Storage Server 69