sa8220 - User Guide

C H A P T E R 3 HP Traffic Director Server Appliances User Guide

Boot Monitor

Commands

Boot Monitor CLI commands (listed below) are described in this

chapter.

autoboot Enables or disables the Autoboot function. When Autoboot is

enabled, the SA8220 prompts you to press a key during restart to

enter the Boot Monitor command line interface. If you ignore the

prompt, restart finishes with the SA8220 in normal operating mode.

If Autoboot is disabled, the restart sequence ends by displaying the

Boot Monitor interface.

Example:

monitor>autoboot

Enable Autoboot? (yes,no) [yes] --->

boot Boots the device with a specific configuration. Variations on use of

the reboot command are described below.

Reboot with No Configuration Changes

1. Type the boot command.

The Boot Monitor displays the current configuration prompts

you for confirmation, as shown in the example below:

• autoboot • info

• boot • interface

• delete • ip

• dhcp • load

• dir • netmask

• dns • rich_bias

• dual • save

• factory_reset • settime

• failover • setup

• gateway • static_routes

• help • version

• host