sa8220 - User Guide

C H A P T E R 3 Using the Boot Monitor CLI

failover Specifies the SA8220’s failover method. Three failover options are

available:

• disabled: no failover method will be used

• serial: serial cable failover will be used

• route: router failover will be used

Example:

monitor>failover

Specify failover method (disabled, serial,

route): [disabled] --->serial

Checking for failover unit...

Failover unit not detected or may not be

configured.

Is this machine Primary or Backup?

[Primary] --->

Enter the Network side Online IP Address

--->

10.6.3.200

Enter the Server side Online Address

--->10.6.5.200

Enter the Network side Online hostname

--->net-onlinehost

Enter the Server side Online hostname

--->serv-onlinehost

Serial failover successfully configured

gateway Specifies the default gateway.

Example:

monitor>gateway

Enter default gateway: --->10.6.3.1

help Lists all Boot Monitor commands or optionally displays syntax for a

specified command.

Example:

gateway Set default gateway

interface Configure network interface card