HP e-Commerce / XML director server appliance sa8250 - Users Guide

C H A P T E R 4 HP e-Commerce/XML Director Server Appliance SA8250 User Guide
114
OSPF Protocol
NOTE: Unless the
config route
protocol
command is
set to
ospf, OSPF
protocol is not active.
For more information,
see Chapter 5.
The Router tab’s OSPF Protocol box specifies the following values:
• OSPF Area: This value must be set to the same OSPF area as the
ingress router to which the SA8250 is talking. This can be the
keywords "backbone" or “Default,” an integer, or dotted decimal
format (xxx.xxx.xxx.xxx). The integer range is from 0 to
2,147,483,647, and the default is Default.
• Hello Interval: The number of seconds between hello packets
sent on this interface. This value must match the hello interval of
the ingress router. The valid range is from 1 to 65,535, and the
default is 10.
NOTE: The Router Dead
value must be at least four
times the Hello interval.
• Router Dead Interval: The number of seconds the SA8250's
OSPF neighbors should wait before assuming this OSPF SA8250
is down. This value must match the router dead interval of the
ingress router. The valid range is from 1 to 2,147,483,647, and
the default is 40.
Authentication type and key are security mechanisms to
guarantee that routing information is exchanged only with trusted
routers. The type and key together comprise the "authentication
scheme." An OSPF Area can have only one OSPF
Authentication scheme.
NOTE: Both sides of the
OSPF connection must
use the same
authentication type and
key and key ID if
applicable.
• Authentication Type: Specifies the type of OSPF authentication.
To disable OSPF authentication, click None. To enable Simple
password authentication, click Simple and then proceed to the
Authentication Key field. To enable MD5 authentication, click
MD5, then enter an authentication key and key id.
• Authentication Key: A user-specified string (excluding double
quotes and spaces) used as an authentication password. The
authentication key is from 1 to 8 characters for Simple
authentication, and 1 to 16 characters for MD5 authentication.
• Confirm Authentication Key: Re-enter the Authentication Key to
verify it to the SA8250.
• Key ID: MD5 key id, an integer from 1 to 255. MD5
authentication provides a stronger level of security for OSPF
users.