HP e-Commerce / XML director server appliance sa8250 - Users Guide

C H A P T E R 5 Global System Commands
167
quit, exit, logout
Exit the CLI
reboot
Reboots the SA8250
reset
Resets the SA8250 to its original factory configuration. Only
parameters set within the CLI are affected. Networking
parameters controlled through the Boot monitor are not affected by
the reset command.
Note 1: Reset causes all policy groups, services, and servers to be
deleted.
Note 2: This operation disables all remote administration access.
Use the
config sys security command to enable remote
access.
CLI Factory Settings:
• Telnet port is set to 23.
• Prompt is reset to product name.
• Maximum telnet sessions is set to 3.
• Scrolling is disabled.
• Idle timeout is set to 90 seconds.
• Maximum login attempts is set to 3.
• Unit ID is set to the factory value.
• IRV is disabled.
• SSH port is set to 22.
• Screenlines is set to 25.
GUI Settings:
• Response timeout is set to 30 seconds.
• Broker-action is set to 0 (Policy Manager).
• Server-action is set to 1 (Statistics)
Multi-site Settings:
• MSD port is set to 1999.
Command Description
Global System Commands (continued)