HP e-Commerce / XML director server appliance sa8250 - Users Guide

C H A P T E R 5 HP e-Commerce/XML Director Server Appliance SA8250 User Guide
182
Routing
Commands
The Routing Commands are used both in route and serial failover
modes. In serial failover mode, they advertise routes to the VIPs.
NOTE: Latency exists in
the refresh process of
normal routing tables. If
you configure OSPF
routing protocol for a
SA8250 on a specific
router, VIP destinations
may be inconsistent in the
routing table. Also, if you
change the role from or to
Standalone you must
specify the protocol on
the same line.
This is critical for VIPs that are not in the same subnet as the SA8250.
If you use route failover, you must configure a routing protocol
(OSPF or RIP) appropriate to your router.
Use of the first two commands in this section, config route role and
config route protocol, must be coordinated. If role is set to
"
standalone," then protocol must be set to "none." If role is set to
"
primary" or "backup," then protocol must be set to OSPF or RIP,
(such as
config route role standalone protocol none).
For example:
config route role standalone protocol disable
or
config route role primary protocol ospf
Command Description
config route ospf-area
Changes the OSPF area.
Note:
ospf-area must be set to the same OSPF area as the
ingress router to which the SA8250 is talking. This can be the
keyword, "backbone," or an integer from 0 to 2,147,483,647, or
dotted decimal format (xxx.xxx.xxx.xxx).
config route ospf-area [backbone | <area>]
where:
•
backbone sets the OSPF area to backbone (0.0.0.0)
•
area is the OSPF area ID.
config route ospf-hello
Changes the OSPF hello interval. The hello interval is the number
of seconds between hello packets sent on this interface. This must
match the hello interval of the ingress router. The valid range is 1
to 65535, and the default is 10.
config route ospf-hello <nseconds>
where nseconds is the number of seconds in the hello interval.
Routing Commands