HP e-Commerce / XML director server appliance sa8250 - Users Guide

C H A P T E R 6 SA8250 Scenarios
237
Prerequisites for Scenario 1
• Two web servers are configured with replicated content. In this
example they are referred to as “serv1.acme.com” and
“serv2.acme.com” with IP addresses of 10.6.1.99 and 10.6.1.100,
respectively.
• One SA8250 is installed between two distinct subnets. The
outside subnet is connected to the router, and the inside subnet is
connected to the switch.
• The SA8250 must be physically installed on the network, and its
Boot Monitor and routing protocol configurations must be
complete. For more information, see the Getting Started Guide.
Procedure for Scenario 1
NOTE: Remember that
all commands you need to
type at the terminal
appear in
bold in this
text.
1. Type these SA8250 initial configuration commands:
monitor>setup
Enable dual NIC operation(yes,no)? [no] ---> yes
Autoconfigure the Network side NIC speed and
duplex? (yes,no)? [yes] --->
Autoconfigure the Server side NIC speed and
duplex? (yes,no)? [yes] --->
DHCP is disabled for dual NIC operation.
Enter the hostname you would like to assign to
the Network NIC: --->tcslab
Enter the IP address for the Network side NIC
--->10.6.3.21
Enter the IP address for the Server side NIC
--->10.6.5.21
Enter the Netmask for the Network side NIC
--->255.255.255.0
Enter the Netmask for the Server side NIC
--->[255.255.255.0] --->255.255.255.0
Enter default gateway: --->10.6.3.1
Would you like to configure DNS (yes, no)? [no]
--->DNS not configured.
Specify failover method (disabled, serial,
route): [disabled] --->
Set Autoboot? (yes,no) [no] --->