HP e-Commerce / XML director server appliance sa8250 - Users Guide

C H A P T E R 3 HP e-Commerce/XML Director Server Appliance SA8250 User Guide

System

Requirements

You can use any terminal or workstation with a terminal emulator to

run Boot Monitor, provided the terminal has the following features:

• 9600 bits per second, 8 data bits, 1 stop bit no parity, no flow

control (9600-8-N-1)

• A terminal emulation program, such as HyperTerminal*

• Cable and connector to match the male DTE connector (DB-9)

Accessing the

Boot Monitor

You can access the Boot Monitor in either of the two ways described

below.

Interrupting the Bootup Sequence

1. Interrupt the SA8250's bootup sequence by pressing a key at the

following prompt:

Press any key to stop autoboot.

In a few seconds the following prompt displays, confirming that

the Boot Monitor is running:

monitor>

Using the Run Time CLI

1. Type this command at the prompt:

HP SA8250#config sys autoboot disable

2. Type this command at the prompt:

HP SA8250#reboot

The monitor> prompt displays, confirming that the Boot

Monitor is running.