HP e-Commerce / XML director server appliance sa8250 - Users Guide

C H A P T E R 3 Using the Boot Monitor
63
Boot Monitor
Commands
This section lists and describes all Boot Monitor commands available
on the SA8250.
autoboot Enables or disables the Autoboot function. If Autoboot is enabled
(the default), the SA8250 prompts you to press a key during restart to
enter the Boot Monitor command line interface. If you ignore the
prompt, restart finishes with the SA8250 in normal operating mode.
If Autoboot is disabled, the restart sequence ends by displaying the
Boot Monitor interface.
Example:
monitor>autoboot
Enable Autoboot? (yes,no) [yes] --->
boot Boots the device with a specific configuration. Variations on the use
of the reboot command are shown in this section.
Reboot with No Configuration Changes
NOTE: The first boot
after a
factory_reset
command or a new
installation will prompt
you for the root
password.
1. Type the
boot command.
The Boot Monitor displays the current configuration and prompts
you for confirmation:
Current active configuration
----------------------------
Product: HP SA8250
Version: 2.7
Patch Level: 0.0
Build: 12
Current time: Tue Sep 12 17:02:05 2000
Hostname: CSLab7k
-------------
Network side NIC:
IP Address: 10.6.3.21
Netmask: 255.255.255.0
MAC address: 0:a0:c9:ed:6c:cc
-------------
Service side NIC:
IP Address 10.6.5.21
Netmask: 255.255.255.0
MAC address: 0:d0:b7:6:c1:85
-------------