RAID User Guide
Table Of Contents
- Introduction
- RAID technology overview
- Operating systems and devices supported
- Intel Rapid Storage Technology features
- RAID volume setup
- Resetting RAID drives to non-RAID
- Frequently asked questions
- Can more than one RAID volume be installed on a computer?
- Is RAID supported to allow both RAID 0 and RAID 1 on a single RAID volume?
- Can the computer be undocked if the recovery HDD is in the docking station SATA-swappable bay?
- What are the maximum number of HDDs that can be connected to the system during boot when the storage ...
- Index
4. In the Device Configurations window, select RAID under SATA Device Mode. Click Confirm.
The following message is displayed: “Changing this setting may require reinstallation of your
operating system. Are you sure you want to proceed?”
NOTE: The HDD image supplied with your computer contains drivers that allow you to switch
between AHCI and RAID modes without reinstalling the operating system. If you use a different
HDD image, you may need to reinstall the operating system.
NOTE: Below SATA Device Mode, there is a check box for Ctrl I Prompt. If this is selected, the
Intel option ROM screen is visible during the computer bootup time.
5. Select File > Save Changes and Exit. Then, click Yes to save the changes. If you do not want
to apply your changes, select Ignore Changes and Exit.
CAUTION: Do NOT turn the computer power off while the ROM is saving the f10 Computer
Setup changes, because the Complementary Metal Oxide Semiconductor (CMOS) could
become corrupted. Turn the computer off only after exiting the f10 Setup screen.
6. After the operating system boots, you can begin the RAID migration procedure.
14 Chapter 5 RAID volume setup