HP StorageWorks Enterprise Modular Library E-Series Getting Started (AD560-96030, September 2007)

Turn the center-door knob one-quarter turn counter-

clockwise and open the center door of the library.

Remove the shipping

restraints

Remove the hold-down brackets.

Move the library to the location

where you want to install it.

Pull down the yellow gear lock that is inside the library

on the right side of the robotics unit to disengage it

from the reduction gear. The gear lock remains

attached to the robotics unit.

Remove the two shipping straps from the bottom of the

robotics unit. Remove each strap by pulling down near

the front end and moving it to the side until the strap

releases from the slot on the front of the library, and

then lift the strap out of the slot on the back of the

library.

NOTE: If you can’t reach the yellow gear lock,

remove the arrays from the top, right wall inside

the library. Press the release lever on the array

and lift the array out of the slot on the wall.