HP StorageWorks Enterprise Modular Library E-Series 71e Getting Started (AH876-96002, October 2007)

Connect the cables
45
CAUTION! To avoid damaging Fibre Channel
(FC) cables, do not pinch or sharply bend the
cable tighter than a 5-centimeter (2-inch)
diameter. Allow a radial bend when attaching
an FC cable to a cable clip.
Install the cable
management features
43
Attach the two cable management features with T-25
Torx screws.
44
Attach the cable
clamps to the right
rear rack at the
positions 37T, 26T,
and 15T. Use
these cable clamps
to route the tape
drive Ethernet
cables.
26
Install the tape drives
42
At the rear of the library, insert a tape drive into an
empty drive bay. Tighten the thumbscrew to attach the
tape drive to the drive bay. Repeat for each tape drive.
NOTE: HP recommends that you install tape
drives from top to bottom with no gaps between
them.
NOTE: Your library might look different.
1
6
2
3
4
5
LTO3 tape drives
1. Library robotics
controller
2. e2400-FC 4Gb
interface
controller
3. To hosts
4. Interface
Manager card
5. To management
station
6. Tape Drives