HP StorageWorks Enterprise Modular Library E-Series 71e Getting Started (AH876-96002, October 2007)

front
vorderseite
anter
ior
recto
fronte
v
oorkan
t
4
U
8
U
HP
S
torag
eW
o
rk
s
E
M
L
se
ries
t
a
pe libra
r
y
A
H
06
2
-
9
6
0
0
4
3
At the rear of the rack, install four mounting brackets at
the locations indicated on the back of the template. Use
two T-15 flathead screws and washers in each
mounting bracket.
5
Use the template shipped with the library to mark the
front and back of the rack with the locations of the
mounting hardware.
If your library contains LTO4 tape drives or if you plan
to add them later, leave an additional 1U of space
above the template in which to install the switch. HP
recommends that you leave 2U of space above the
library for future expansion, if possible.
4
At the front of the rack, install six clip nuts at the
locations indicated on the front of the template.
Also install one clip nut in each rail.
For the top mounting
brackets, place a rail on
top of each mounting
bracket. At the front of the
rack, attach the rails at the
locations indicated on the
front of the template. Use
one T-15 flathead screw
and washer in each rail.
6
Rear of rack
Front of rack
Front of rack
Rear of rack