HP StorageWorks Enterprise Modular Library E-Series 71e Getting Started (AH876-96002, October 2007)

Remove the two bottom arrays from the back column of
arrays on the right wall. (You are removing one 6-slot
array from the 8U base module and one 6-slot array
from the 4U base module.) To remove an array, press
its release lever and lift up on the array.
26
21
Replace the 4U blank cover on the 4U base module.
24
Fold the cables so they fit under the covers. Replace the
metal cover and the black protective cover.
Insert the lift pole
25
1
2
Inside the front of the library, insert the lift pole onto the
pole mount at the lower left corner of the back wall of
the 4U base module. Press down on the pole until the
top of the pole slips into the pole mount in the 8U base
module above it.
Plug in the OCP cables
22
Remove the two T-10 Torx screws from the bottom-left
and top-right corners of the black protective cover that
is on the back of the Operator Control Panel (OCP).
Remove the two T-15 Torx screws from the metal cover
on the upper door to access the cables.
Release lever
Plug in the inter-module
power cable
Plug the two ribbon cables into the back of the OCP.
23