HP StorageWorks ESL E-Series e2400-FC 2Gb Interface Controller Replacement Instructions (AA928-96015, September 2007)

ACT/
LNK
ACT/
LNK
PORT 1 PORT 0 ETHERNET
SERIAL
PWR
FIBRE
CHANNEL
FIBRE
CHANNEL
ACT/
LNK
PORT 2
FIBRE
CHANNEL
ACT/
LNK
ACT/
LNK
PORT 1 PORT 0
FIBRE
CHANNEL
FIBRE
CHANNEL
ACT/
LNK
PORT 2
FIBRE
CHANNEL
ACT/
LNK
ACT/
LNK
SERIAL
PWR
FIBRE
CHANNEL
FIBRE
CHANNEL
ACT/
LNK
FIBRE
CHANNEL
ACT/
LNK
ACT/
LNK
FIBRE
CHANNEL
FIBRE
CHANNEL
ACT/
LNK
FIBRE
CHANNEL
ACT/
LNK
ACT/
LNK
PORT 1 PORT 0 ETHERNET
SERIAL
PWR
FIBRE
CHANNEL
FIBRE
CHANNEL
ACT/
LNK
PORT 2
FIBRE
CHANNEL
ACT/
LNK
ACT/
LNK
PORT 1 PORT 0
FIBRE
CHANNEL
FIBRE
CHANNEL
ACT/
LNK
PORT 2
FIBRE
CHANNEL
ACT/
LNK
ACT/
LNK
SERIAL
PWR
FIBRE
CHANNEL
FIBRE
CHANNEL
ACT/
LNK
FIBRE
CHANNEL
ACT/
LNK
ACT/
LNK
FIBRE
CHANNEL
FIBRE
CHANNEL
ACT/
LNK
FIBRE
CHANNEL
Installation
7
8
Use a #1 Phillips screwdriver to loosen the captive
screws in the black ejector handles at both ends
of the e2400-FC 2Gb interface controller.
Push the ejector handles toward the outside,
then pull on them to remove the controller.
6
Flip the two breaker switches off (to the left) at the
power distribution unit.
9
Take note of the cable connections for identical
reconnection to the replacement controller. Carefully
disconnect the Fibre Channel (FC) and Ethernet
Orient the interface controller as shown. Align the
interface controller with the guides in the
appropriate slot and slide it into the library. Push
the ejector handles to the inside to fully seat the
controller. Using a #1 Phillips screwdriver, tighten
the ejector handle screws.
5
Power off the library.
a. Use your backup software to verify that
the picker is empty, or to empty the picker.
b. Press the power button located on the
front of the library and wait until the OCP
goes blank.
cables from the e2400-FC 2Gb interface controller
by pressing on the connector tabs and remove the
cables.
LTO3 LTO4