HP StorageWorks ESL E-Series SCSI Tape Drive Replacement (350802-004, January 2009)

Using a flathead screwdriver, loosen the captive
screw at the upper left corner of the tape drive
module. Grasp the drive where the fan is located
and pull the drive from the cluster.
78
5
From the OCP, power off the drive to be replaced.
a. From Menu, select the Ops button.
b. Use the Up and Down buttons to select the
drive, then press the Select button.
c. Use the Up and Down buttons to change the
drive to off-line, then press the Select button.
d. Select the Back button to return to Menu.
Cable Removal
6
Remove the SCSI terminator and the SCSI cable
attached to the failed drive. Note the cable
connections so that they can be reattached to the
replacement drive in the same manner.
Push the new drive all the way into the cluster
and tighten the captive screw to secure the drive.
Reattach the SCSI terminator and SCSI cable to
the replacement drive plate.
9
Check to see that the drive LED is green, and that
the cluster controller LED also shows green for the
replacement drive.
10