6625 Disk Enclosure Installation Instructions (5697-1395, December 2011)

Adding above the controller enclosure

Complete the following procedure to add a disk enclosure above the controller enclosure.

1. Figure 14 (page 15) shows the cabling when a disk enclosure is added above the controller

enclosure. Unplug the DP-2 cable from I/O module port P1 of the existing disk enclosure nearest

the newly installed disk enclosure and plug it into port P1 of I/O module A of the newly installed

disk enclosure (1, Figure 14 (page 15)).

Figure 14 Adding a disk enclosure above the P6500 EVA

Table 4 Adding a disk enclosure above the P6500 EVA callouts

DescriptionCallout

Connects installed I/O module A, port P1 to controller 1, port DP-A (using the DP-2 cable)1

Connects installed I/O module A, port P2 (above controller) to existing I/O module A, port P12

Connects installed I/O module B, port P1 (above controller) to controller 2, port DP-B (Red) (using the

DP-2 cable)

Connects installed I/O module B, port P2 (above controller) to existing I/O module B, port P14

Cabling the enclosure 15