6625 Disk Enclosure Installation Instructions (5697-1395, December 2011)

Installing the disk enclosure

1. Slide the device into position on the rails (1, Figure 2 (page 5)) and then tighten the thumbscrews

(2) on the front of the device to secure the device to the rack.

Figure 2 Secure disk enclosure to rack

NOTE: The rear ends of the rails have a CTO bracket that must engage the device chassis to

secure the rear of the chassis to the rails (Figure 3 (page 5)).

Figure 3 Engaging CTO bracket

2. When cabling the device, use holes provided in the rear rack rails, install tie wraps, and route

external cable as required (Figure 4 (page 6).

NOTE: The minimum bend radius for SAS cables is 2.0 in. (5.1 cm) — the illustration may not

reflect this specific size.

Installing the disk enclosure 5