HP EVA Updating Product Software Guide (xcs10001000) (5697-2423, December 2012)

Figure 26 I/O tab of Disk Enclosure Properties window

NOTE: The Firmware revision fields are different for EVAx400 and P6000 disk

enclosures.

If the fields Assembly serial number, Hardware revision, and Hardware type on the I/O

tab of the Disk Enclosure Properties window are blank, you can optionally reset the I/O

modules to clear the blank fields after the I/O module firmware upgrade has completed

successfully. Note that blank fields do not affect the array's ability to process host I/O.

See “Resetting the I/O module” (page 54) for more information.

e. Check the operational states that you recorded and proceed as follows:

• Good: No action

• Loading firmware: The I/O module firmware load is blocked. Corrective action is

required somewhere on the array (but not on this I/O module). Continue with Step

• Any state other than Good or Loading firmware: Corrective action is required on

this I/O module. Continue with Step 18.

18. Check the event log for the code-load-blocked code (066df308, critical event). If you do not

see this event, contact your HP-authorized service representative for assistance. If you see this

event, continue with Step 19.

Step 5. Upgrading the controller software 53