HP StorageWorks Power Supply/Blower Replacement Instructions (5697-5527, January 2006)

HP StorageWorks
Power Supply/Blower
Replacement Instructions
These instructions apply to the MSA30, MSA 1000,
EVA 3000/5000, and EVA 4000/6000/8000
product families. The part may also be used in other
HP products. Please refer to documentation for your
specific product for detailed replacement instructions.
Printed on
at least 50% total recycled fiber with at least
10% post-consumer paper.
©Copyrigh
t 2005-2006 Hewlett-Packard Development Company,
L.P.
Second edition January, 20 06
Product names mentioned herein may be trademarks of their
respectivecompaniesasreflected by an associated footnote.
The information in this document is subject to change without
notice.
Printed in Puerto Rico.
www.hp.com
.
*5697-5527*
Warranty Inform
ation
If the product in
whichthispartisbeingreplacedisstillunder
HP warranty, then the replacement part(s) referred to in these
Replacement Instructions is provided un der the terms and conditions
of the Hewlett-Packard Company Limited Warranty for tha t
product. A copy of this Limited Warranty may be viewed at:
h
ttp://h1 8006.www1.hp.com/products/storageworks/warranty.html
If this is a tra
de sale part (product out of warranty) , then the replacement
part(s) refe
rred to in these Replacement Instructions is provided under
HP's express
limited warranty statement, which may be viewed at:
h
ttp://cust
omerops.corp.hp.com/1sw/pdm_om/warranty_support/
policies/2
330100.doc
The replace
ment part takes on either the Limited Warranty Period of the
part being r
eplaced or a ninety-day period that begins upon installation
of the replacement part, whichever is greater.
The only wa
rrantyforthisreplacementproductisasnotedabove.
Nothing in
these replacement instructions should be construed as
constituting an additional warranty. The information provided in these
replacem
ent instructions is provided "AS IS" and HP is not liable for
technic
al or editorial errors or omissions contained herein.
About This Document
This document describes the procedure for replacing the power
supply/blower assembly used in MSA30, MSA 1000, EVA
3000/5000, and EVA 4000/ 6000/ 8000 products.
NOTE:
Because this component is used in several products, the
drawings may reflect a different enclosure than the one you
have. The removal and replacement procedure is the same
for each product.
Before you begin
Observe the following precautions when replacing the power
supp
ly/blower .
CAUTION:
You h
ave o nly seven minutes to perform the replacement
pro
cedure! Both power supplies must be installed for the
enc
losure to cool properly. If a power supply fails, leave it in
pla
ce in the enclosure until a new power supply is available
to i
nstall. The enclosure could shut down due to overheating
unless the power supply is replaced within seven minutes of
removal of the failed/failing power supply.
If cabling is obstructing access to the power supply/blower,
carefully move the cables out of the way to avoid loosening
any connections.
Parts can be damaged by electrostatic discharge. Use proper
anti-static protection. Refer to the documentation that shipped
with your system for additional information.
Have a copy of the product User Guide available for reference.
You can download a copy of the User Guide from the product
support page on the HP web site.
Page 1