HP StorageWorks EVA Web-based Operator Control Panel 1.0 user guide (5697-7492, July 2008)

IMPORTANT:
When your LAN is part of a public network, HP recommends that you temporarily disconnect from the
public network while performing this procedure.
1. If currently connected, disconnect the public network LAN cable from the back of the management
module in the controller enclosure.
2. Press and hold the recessed Reset button for 4 to 5 seconds. This sets an IP address of 192.168.0.1 in
private address space. The amber indicator on the top right corner of the LAN connector (Ethernet
jack) will flash momentarily when the reset operation is completed.
IMPORTANT:
At initial setup, you cannot browse to the WOCP until you perform this step.
1. LAN connector 2. Reset but ton 3. Management module
3. Do one of the following:
• Temporarily connect a L A N cable from a private network to the management module.
• T emporari
ly connect a laptop computer directl y to the management module using a LAN patch
cable.
4. Browse to https://192.168.0.1 :2372 and log in as an HP EVA administrator. The default user name
is admin.
No password is required. The WOCP GUI appears.
IMPORTAN
T:
If you cha
ngethepasswordfortheadministratororuseraccountfortheWOCP,besureto
record the new passwords since they cannot be cleared without resetting the management
module.
HP recommends that you change the default passwords.
5. Select Administrator Options > Configure Network Options.
6. Enter a new I P address and other network settings that apply.
IMPORTANT:
IP addresses 10.0.0.0 to 10.255.255.255 are not supported. See Private and public networks.
EVA Web-based Operator Control Panel 1.0
15