Manualshelf

HP 30-1002201 Loop Switch CLI Reference Guide (5697-5675, May 2006)

ManualsBrandsHP ManualsComputer AccessoriesHP EVA8000 Loop Switch Option
21222324252627282930
30-10022-01 loop switch CLI reference guide 21
NOTE: Before resetting the switch, ensure that the IP address, netmask, and gateway settings are
appropriately configured.
3. Type root reset and press ENTER.
4. Type y and press E
NTER to reset the switch.
Configuring the IP Address Setting (config/network/ip)
This command configures the IP address for the switch. The IP address format should be separated
by periods. For example, 196.168.0.10.
To change the IP address setting:
1. From the Network Configuration menu (config/network), type ip and press E
NTER.
The switch’s current IP address setting is displayed in brackets before the command prompt.
2. Type the new IP address and press E
NTER.
The switch’s IP address is now saved and will become active once the switch is reset.
Configuring the Network Mask Setting (config/network/mask)
This command configures the network mask setting for the switch. The network mask format should
be separated by periods. For example, 255.255.255.0.
To change the network mask setting:
1. From the Network Configuration menu (config/network), type mask and press E
NTER.
The switch’s current network mask setting is displayed in brackets before the command
prompt.
2. Type the new network mask setting and press E
NTER.
The switch’s network mask setting is saved and becomes active once the switch is reset.
Configuring the Gateway Setting (config/network/gateway)
This command configures the default gateway setting for the switch. For example, 196.168.0.1.
To change the default gateway setting:
1. From the Network Configuration menu (config/network), type gateway and press E
NTER.
The switch’s current default gateway setting is displayed in brackets before the command
prompt.
2. Type the new default gateway setting and press E
NTER.
The switch’s default gateway setting is saved and becomes active once the switch is reset.
Hardware Reset (config/network/reset)
This command resets the switch.
To reset the switch:
1. From the Network Configuration menu (config/network), type reset and press E
NTER.
A confirmation request is displayed.
2. Type y and press E
NTER to proceed with the switch reset.