HP 30-1002201 Loop Switch CLI Reference Guide (5697-5675, May 2006)

30-10022-01 loop switch CLI reference guide 25
4Show Menu (SHOW)
You can view the switch’s current settings at either the Show menu or, for some settings, the specific
submenu.
The Show Menu provides information on current switch settings.
Displaying Events (show/events)
This command displays the event log entries (up to 3000 messages) generated by the switch. Once
the event log reaches the maximum number of entries, it overwrites the oldest entries in the log with
the latest entries. In order to correlate the events with the current time you must first set the time;
otherwise, the time shown in the event log is based on the last reset in hours and minutes.
For a list of the severity levels and event messages, see Appendix A: Event Messages on page 28.
To view the event log:
From the Show menu (show), type events and press E
NTER.
Displaying Port Speeds (show/speeds)
This command displays the speed for each port.
To view the ports’ speed settings:
1. From the Show menu (show), type speeds and press E
NTER.
A list of each port, the current speed, and the current speed configuration is displayed.
Displaying Port Insertion Counters (show/prtctrs)
This command displays the insertions for a single port or for all ports.
To view the insertions for all ports:
From the Show menu (show), type prtctrs and press E
NTER.
To view the insertions for a specific port:
From the Show menu (show), type prtctrs <port number> and press E
NTER.
Command Description Additional Information
1. events Displays the event log. See page 25.
2. speeds Displays the speed for each port. See page 25.
3. prtctrs Displays the error counters for one or more ports. See page 25.
4. prtutilization Displays port utilization information. See page 26.
5. clrctr Clears the counters. See page 26.
6. sysinfo Displays system information. See page 26.
7. galpa Displays the port AL_PAs. See page 26.
8. sensors Displays sensor information. See page 27.
9. sid Displays the SFP serial data. See page 27.
10. stat Displays the Port Statistic Data sub-menu See page 27.
11. dump Displays the switch settings. See page 30.
12. .. Returns to the previous menu. See page 12.
13. ? Displays the current menu. See page 10.