HP 30-1002201 Loop Switch CLI Reference Guide (5697-5675, May 2006)

26 Show Menu (SHOW)
Displaying Port Utilization Information (show/prtutilization)
This command displays the minimum, average, and maximum transmit and receive port utilization for
all ports or for a specific port.
To view the port utilization for all ports:
From the Show menu (show), type prtutilization and press E
NTER.
To view the port utilization for a specific port:
From the Show menu (show), type prtutilization <port number> and press E
NTER.
Clearing Counters (show/clrctr)
This command clears the port counters.
To clear the error counters for all ports:
From the Show menu (show), type clrctr and press E
NTER.
Displaying System Information (show/sysinfo)
This command displays the current switch information.
To display current switch information:
From the Show menu (show), type sysinfo and press E
NTER.
The system information includes the following:
Displaying Port AL_PAs (show/galpa)
This command displays all of the AL_PAs for a single port or for all ports.
NOTE: The SES device’s AL_PA is only displayed if a Loop Initialization Master (LIM) device is attached to
the switch.
To view the AL_PAs for all ports:
From the Show menu (show), type galpa and press E
NTER.
To view the AL_PAs for a specific port:
From the Show menu (show), type galpa <port number> and press E
NTER.
Setting Description
System Name The name assigned to the switch.
Location The location assigned to the switch.
Contact The contact information assigned to the switch.
DHCP Indicates whether DHCP is enabled or disabled.
IP Address The IP address assigned to the switch.
Netmask The netmask assigned to the switch.
Gateway The gateway assigned to the switch.
MAC Address A unique identification number assigned to each switch. Cannot be configured or
modified.
Serial Number A unique identification number assigned to each switch at the factory. Cannot be
configured or modified.
FW Version The current firmware loaded onto the switch. The current version can be replaced by
an alternate version that you have previously loaded onto the switch.
HW Version The hardware version of the switch. Cannot be configured or modified.
Fault Status The current status of the switch.
Current Time The switch’s current date and time.
System Uptime The duration of time that the switch has been operational. If the switch is rebooted or
power is cycled, this value is reset.