AB378B Fibre Channel Mass Storage Adapter Installation Guide, February 2007

Fibre Channel Adapter Installation for HP-UX

Verifying the Fibre Channel Adapter Installation

Chapter 1

NOTE Be sure to use LC-LC or LC-SC cables for the Fibre Channel host bus adapters which use the

FCD driver.

Verifying the Fibre Channel Adapter Installation

1. To verify the adapter installation, enter the command:

# ioscan -f

2. Verify that the following drivers appear for each installed adapter. If all drivers display, proceed to the

Verifying Connectivity section.

The ioscan output might look like the following. The third column represents the hardware path of the

slot in which the adapter is installed. This path will be different for each installed adapter port.

3. If the ioscan output is similar to the following:

fc 0/0/6/1/0 UNCLAIMED UNKNOWN

HP-UX detected the adapter, but the drivers are not properly loaded.

4. If the correct driver is installed and the adapter is not listed in the ioscan output, contact HP for

assistance.

Table 1-1 Cable Products

LC-LC

221692-B21 Fibre Channel Cable 2m LC 50/125 duplex M/M

C7525A Fibre Channel Cable 16m LC 50/125 duplex M/M

221692-B27 Fibre Channel Cable 50m LC 50/125 duplex M/M

LC-SC

221691-B21 Fibre Channel Cable 2m LC-SC 50/125 duplex M/M Optical

C7530A Fibre Channel Cable 16m LC-SC 50/125 duplex M/M Optical

Table 1-2 ioscan -f Output

Class I H/W Path Driver S/W State H/W Type Description

fc 2 0/0/6/1/0 fcd CLAIMED INTERFACE HP AB378-60101 4Gb Single

Port PCI/PCI-X Fibre

Channel Adapter (FC Port 1)