AD300A Fibre Channel Mass Storage Adapter Installation Guide, May 2007

Fibre Channel Adapter Installation for HP-UX
LED Interpretation
Chapter 1
13
LED Interpretation
Obtaining Card Information after Installation
Example of Card information after Installation
# fcmsutil /dev/fcd2
Vendor ID is = 0x001077
Device ID is = 0x002432
PCI Sub-system Vendor ID is = 0x00103c
PCI Sub-system ID is = 0x007041
PCI Mode = PCI Express x4
ISP Code version = 4.0.22
ISP Chip version = 2
Topology = PTTOPT_FABRIC
Link Speed = 2Gb
Local N_Port_id is = 0x030600
Previous N_Port_id is = None
N_Port Node World Wide Name = 0x50060b000058cf05
N_Port Port World Wide Name = 0x50060b000058cf04
Switch Port World Wide Name = 0x200600051e352af4
Switch Node World Wide Name = 0x100000051e352af4
Table 1-3 AD300A LED Interpretation Table
HBA State
Yellow
LED
(4 Gbps)
Green
LED
(2 Gbps)
Amber
LED
(1 Gbps)
Comments
Power OFF OFF OFF OFF Card doesn’t have power
Power ON ON ON ON Card powered on and not initialized
Power ON 1 Flash/s 1 Flash/s 1 Flash/s After firmware initialization AWAITING LINK-UP
All flashing at the same time
Firmware
Fault
2 Flash/s 2 Flash/s 2 Flash/s All three LEDs flash in continuous sequence
1 Gbps Link
UP/ACT
OFF OFF ON
5 Flash/s
ONLINE
IO Activity
2 Gbps Link
UP/ACT
OFF ON
5 Flash/s
OFF ONLINE
IO Activity
4 Gbps Link
UP/ACT
ON
5 Flash/s
OFF OFF ONLINE
IO Activity