AD300A Fibre Channel Mass Storage Adapter Installation Guide, May 2007

Chapter 2
19
2 Fibre Channel Adapter Installation for
OpenVMS
This chapter contains installation prerequisites, guidelines, and procedures for the AD300A host bus adapter.
This chapter addresses the following topics:
“Prerequisites” on page 19
“Installing Driver Software” on page 20
“Installing Adapter Hardware” on page 20
“Attaching the Adapter to Other Fibre Channel Devices” on page 22
“Verifying the Fibre Channel Adapter Installation” on page 22
“Additional Configuration Information” on page 24
“LED Interpretation” on page 24
Thank you for purchasing HP I/O Cards
If you are installing an HP I/O card as an add-in device, please review this document before attempting
installation.
If this card was factory installed in your server, see “Verifying the Fibre Channel Adapter Installation” on
page 22.
HP welcomes your input. Please email us at:
[e-mail]
with comments or suggestions on HP I/O Cards or related documentation.
All product documentation, including a comprehensive Support Guide, Installation Guide, Release Notes,
Support Matrix are available online at: http://docs.hp.com
1. Within the “Internet & Networking” category select “I/O Cards and Networking Software”
2. Select “Fibre Channel”
3. Click on the Fibre Channel documentation product.
Prerequisites
Before installing the adapter, follow these steps:
Step 1. Verify compliance with supported configurations using the HP Fibre Channel Host Bus Adapter
Support Matrix at:
http://docs.hp.com/en/netcom.html#Fibre%20Channel
Step 2. Determine if the adapter is a Customer Replaceable Unit (CRU) using the HP Fibre Channel Host
Bus Adapter Support Matrix. If the adapter is not a CRU, contact your HP representative for
installation assistance.
Field Replaceable Units (FRUs) must be installed or replaced by qualified Hewlett-Packard service
representatives only. CRUs can be installed or replaced by customers or qualified Hewlett-Packard
service representatives.
Step 3. Make sure that you have everything that you need to install the adapter.
• Verify that you have the following items:
— Grounding wrist strap
— Fibre Channel driver software media (included with the OS or application CD)
— Fibre Channel host bus adapter with an optical port protector attached (not included with
all adapters)