AH400A/AH401A - HP PCIe 8Gb 1 port, 2 port, and 4Gb Fibre Channel QLogic HBAs using Linux, Windows, and HP-UX OS's Installation Guide, October 2008

15. Install OnlineDiag, which is available at:
http://h20392.www2.hp.com/portal/swdepot/index.do
OnlineDiag is also available from the HP Support PLUS CD. Installation instructions are
available at:
http://docs.hp.com/en/diag/st/st_inst.htm
Installing adapter online
The Online addition and replacement feature (OL* for HP-UX v2 and later HP-UX releases) allows
PCI host bus adapters to be added or replaced, without shutting down or rebooting the system,
and without adversely affecting other system components. The system hardware uses slot-specific
power control, combined with HP-UX operating system support, to enable these features.
Confirm whether OL* is supported on the system that you plan to install a Fibre Channel adapter.
See the HP Fibre Channel host bus adapter support matrix at the website:
http://docs.hp.com/en/netcom.html#Fibre%20Channel
For detailed instructions on using OL* on HP-UX 11i v2 and later HP-UX releases, see the Interface
card OL* support guide and the Interface card OL* support matrix at this website:
http://docs.hp.com/en/hpux11iv2.html
IMPORTANT: Superdome systems are not intended to be maintained by customers. HP
recommends that Superdome systems only be opened by a qualified HP service provider. Failure
to observe this recommendation can invalidate any support agreement or warranty you may be
entitled.
Installing the adapter offline
The following procedure should only be performed by an authorized HP service provider. Failure
to properly complete the steps in this procedure may result in erratic system behavior or system
failure and may void the warranty. For assistance with this procedure, contact your local HP
Authorized Service Provider.
NOTE: The optical port protector is used only to protect the adapter port when it is not in use.
Do not use the protector as a diagnostic tool.
Install OnlineDiag, which is available at the following website:
http://h20392.www2.hp.com/portal/swdepot/index.do. OnlineDiag is also available from the HP
Support Plus CD for PA-RISC systems or the IPF CD for Itanium®-based systems. Installation
instructions are available at:
http://docs.hp.com/en/diag/st/st_inst.htm
Install all driver software and dependency patches before you install the adapter. See the
FibrChanl-01 (fcd) Fibre Channel mass storage driver release notes available at:
http://docs.hp.com/.
Installing adapter online 19