AH400A/AH401A - HP PCIe 8Gb 1 port, 2 port, and 4Gb Fibre Channel QLogic HBAs using Linux, Windows, and HP-UX OS's Installation Guide, October 2008

Table 4-1 Fibre Channel cable products (continued)
LC-LC
SC-SC
Fibre Channel Cable 15m SC-SC 50/125 Duplex M/M234457–B23
Verify the Fibre Channel adapter installation
1. To verify that the system recognizes the HBA, view the output listing from the following
command:
# ioscan -fnC lan
2. Verify the following drivers appear for each installed adapter. If all the drivers are listed,
proceed to the section titled verifying connectivity.
The ioscan -fnC lan output will display the following:
Class I H/W Path Driver S/W State H/W Type Description
=====================================================================
fc 4 0/4/0/0/0/0 fcd CLAIMED INTERFACE HP AH401A 8Gb Dual Port PCIe Fibre Channel
Adapter (FC Port 1)
fc 5 0/4/0/0/0/1 fcd CLAIMED INTERFACE HP AH401A 8Gb Dual Port PCIe Fibre Channel
Adapter (FC Port 2)
The third column represents the hardware path of the slot that the adapter is installed. This
path will be different for each installed adapter port.
3. Observe whether the ioscan output reports the following:
fc 0/7/0/0/0/0 UNCLAIMED UNKNOWN
If reported, HP-UX detected the adapter but the fcd driver is not recognized.
4. If the correct driver is installed and the adapter is not listed in the ioscan output, contact
HP for assistance.
Obtaining card information after installation
Review the following reports for HBA card information after installation.
Verify the Fibre Channel adapter installation 21