FibrChanl-01 (fcd) B.11.31.1303 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

Table 17 HP-UX September 2008 Fixes
DescriptionDefect ID
There are no fixes for the September 2008 release.N/A
Table 18 HP-UX March 2008 Fixes
DescriptionDefect ID
Added Symbolic Name support. Symbolic Names are user friendly names assigned to SAN
components, and registered with the name server of an FC switch. FC switches display the
QXCR1000754446
registered symbolic names, which can be used by users to correlate SAN components across
multiple servers and storage.
Display fcd controller symbolic port and node names from HP-UX:
# /opt/fcms/bin/fcmsutil /dev/fcdl
fcd controller symbolic port and node names are displayed as N_Port Symbolic Port Name
and N_Port Symbolic Node Name.
Table 19 HP-UX September 2007 Fixes
DescriptionDefect ID
Enable DLKM for 11.31SR: 8606477107
Support online transceiver diagnostics – sfpSR: 8606479804
Avoid use of /tmp file for driver dumpsSR: 8606477715
Modify FCD dump driver to support > 2TB LUNsSR: 8606466124
Known problems and limitations
This section provides a list of known problems and limitations as known to HP at time of publication.
If workarounds are available, they are included.
• CRA report shows internal failures reported during “olrad –r”
When existing cards which have been claimed in last boot are moved into the powered off
state, and are later added to the system using the olrad -A command, the OL* script of
FCD does not create special device files corresponding to the FCD cards present under the
PCI slot. Failure to create these special device files leads to the following error being reported
in the CRA phase of olrad -r, and the replacement of the current card on the system fails.
—
CRA REPORT SUMMARY: CRA encountered INTERNAL FAILURES.
Detailed CRA report is available in /var/adm/cra.log file.
CRA Error : ERROR occurred during analysis
Target slot : 11-0-2-0-0-4
--
See CR QXCR1001233122.
This issue is seen only with Superdome 2 (CB900s i4).
Corrective action:
This is a known issue and can be resolved by issuing the following insf(1M) command after
the completion of the olrad -A command:
#insf -e -C fc
Known problems and limitations 7