FibrChanl-01 (fcd) Fibre Channel Mass Storage Driver for HP-UX 11i v2 Release Notes (September 2009)

Table 6 HP-UX 11i v2 December 2007 Fixes
DescriptionDefect ID
fcd driver fails HBA initialization, when WEL bit is set in the NVRAM status register.CR: JAGag48556
Fixed an out-of-bounds array reference in the fcd SNIA library that caused core dumps.
Fixed an infinite loop condition in the fcd SNIA library.
CR: JAGag41528
Table 7 HP-UX 11i v2 September 2007 Fixes
DescriptionDefect ID
Fixed fcmsutil to accept the multiboot image with embedded firmware for flashing.SR: 8606487612
Panic due to cdio list getting corruptedSR: 8606483960
Table 8 HP-UX 11i v2 April 2007 Fixes
DescriptionDefect ID
Fixed a problem where the system hung with an STK 9940B tape drive, when connected to
a 4 Gb card.
SR: 8606468464
Fixed a problem by removing an unwanted diagnostics message for initiator ports, Device
disappeared from Name Server GPN_FT.
SR: 8606467276
Fixed a problem where a path failover was seen with a split cable disconnection from switch
Rx.
SR: 8606472417
Fixed an ioscan hang which occured when a switch assigned the same domain and area
(part of Nport ID) to the HBA and a target device.
SR: 8606475031
Fixed a problem where fcddiag and fcdlist were saving results in /tmp, instead of in /opt/
fcms/debug (for root users only).
SR: 8606463837
Table 9 HP-UX 11i v2 December 2006 Fixes
DescriptionDefect ID
Fixed a problem which caused unexpected data to be displayed when the fcmsutil
read_cr option is used with 2 Gb fibre channel HBAs.
SR: 8606456492
Fixed a problem in which firmware reports a fatal error was detected on 4 Gb fibre channel
HBAs.
SR: 8606449173
Fixed a problem in which the fcd driver reports a “Mailbox 0x69 Timeout.”SR: 8606454863
Fixed a problem in which firmware sometimes fails to bring the link up after a cable
disconnect / reconnect with 2 Gb fibre channel HBAs.
SR: 8606450588
Table 10 HP-UX 11i v2 September 2006 Fixes
DescriptionDefect ID
Resolved a problem that could cause a system panic when attempting an online update of
the fibre channel controller's firmware or EFI driver.
SR: 8606439680
Resolved a problem that could cause a 4Gb link to come up in public loop mode rather than
fabric mode.
SR: 8606451612
Resolved a problem that could cause a dump failure if there is a delay in obtaining the state
of the controller port.
SR: 8606447218
6