FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v2 Release Notes Version Number B.11.23.1104 HP Part Number: 5900-1797 Published: April 2011 Edition: 1.
Contents FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v2 overview.............................3 New and changed features in this release...................................................................................3 New features......................................................................................................................3 Known problems fixed in this version...........................................................................................
This document provides information about the B.11.23.1104 release of the FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v2. FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v2 overview This release of the document for the FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v2 (version B.11.23.1104) documents defect fixes and version changes. New and changed features in this release New features The following feature is new with the B.11.23.
Table 5 HP-UX March 2009 Fixes Defect ID N/A Description There are no fixes for the 0903 release. Table 6 HP-UX December 2008 Fixes Defect ID Description QXCR1000860999 The case where the fclp driver timed out on an I/O operation too soon has been fixed. QXCR1000871619 The case where the fclp driver did not recognize a single device with a loop ID of 0 on a private loop has been fixed.
• fcmsutil Command reports an error when run with /dev/fclpX Load patch PHKL_36143. • EFI boot fails with no HP-UX partition on boot media message Loading.: HP-UX Primary Boot: 0/4/0/0/0/0.8.0.20.0.3.0 Starting: HP-UX Primary Boot: 0/4/0/0/0/0.8.0.20.0.3.0 Using EFI boot partition (no HPUX partition on boot media) HP-UX Boot Loader for IPF -- Revision 2.029 Press Any Key to interrupt Autoboot \EFI\HPUX\AUTO ==> boot vmunix Seconds left till autoboot 0 AUTOBOOTING...
9. • After completing your scanning policy selection and configuration, use the ESC key to exit the EFI configuration menus. Host bus adapters using the fclp HP-UX driver stay in AWAITING LINK UP state when connected to a DS2500 device The solution to this issue is to set the speed of the adapter port to 2 Gb, by using the drvcfg -s command at the EFI shell prompt, to configure the port speed: 1. 2. 3. 4. 5. 6. 7. 8. 9.
Compatibility and installation requirements This section describes the compatibility information and installation requirements for this release. For specific installation instructions, refer to the installation guide specific to your to your FibreChannel card. NOTE: FibrChanl-02 on HP-UX 11i v2 is supported with VxVM 4.1 or later, including boot and Ignite/UX.
NOTE: vpd Display EFI driver and ROM firmware versions using fcmsutil EFI/firmware bundles can be downloaded from www.hp.com, in the Software and Driver Downloads section. Hardware requirements This version of the FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v2 runs on HP Integrity servers with the HP-UX 11i v2 (11.23) operating system.
