FibrChanl-02 (fclp) B.11.23.1104 Fibre Channel Mass Storage Driver for HP-UX 11i v2 Release Notes

Compatibility and installation requirements
This section describes the compatibility information and installation requirements for this release.
For specific installation instructions, refer to the installation guide specific to your to your
FibreChannel card.
NOTE: FibrChanl-02 on HP-UX 11i v2 is supported with VxVM 4.1 or later, including boot and
Ignite/UX.
Operating system and version compatibility
The following software (or later versions) must be installed before installing the FibrChanl-02 (fclp)
driver, version B.11.23.1104 into a system:
• FibrChanl-00 (td) version B.11.23.03 or later (for HP-UX 11i v2 Update 3)
• Fibre Channel Mass Storage (FCMassStorage) version B.11.23.03 or later
• Product number B6191AAE, OnlineDiag bundle version B.11.23.0903, released in March
2009 (HWE0903)
• PHKL_36363 patch or later (for HP-UX 11i v2)
• PHKL_36143 patch (needed to enable thefcmsutil command to work properly with cards
that use the fclp driver)
• PHKL_31500 patch or later (needed for HP-UX 11i v2)
• PHKL_34851 (needed for HP-UX 11i v2)
Driver bundles can be downloaded from the HP Software Depot at: http://www.software.hp.com
Patches are available from either: http://www.software.hp.com or http://itresourcecenter.hp.com
OnlineDiag is available at http://www.software.hp.com in the Enhancement releases and patch
bundles section, or on the HP-UX 11i v2 OE media (September 2004 and later). Installation
instructions are available at: http://www.hp.com/go/hpux-iocards-docs, by clicking onHP-UX 11i
v2 I/O Cards .
Requirements for boot support: AD355A and AD299A
To boot through the fibre channel ports on these adapters, HP recommends that you update the
EFI driver and onboard firmware to the latest version. The following table lists the recommended
EFI and firmware versions at the release of FibrChanl-02 (fclp) driver, version B.11.23.1104:
Table 9 Recommended Firmware Versions (April 2011)
Firmware versionEFI driver versionFibre channel adapter
2.70X5 or later3.21A3 or laterAD355A
2.70X5 or later3.21A3 or laterAD299A
For current recommended firmware versions, see the HP Fibre Channel Host Bus Adapter Support
Matrix at http://www.hp.com/go/hpux-iocards-docs, by clicking onHP-UX 11i v2 I/O Cards .
If your Fibre Channel adapter is not listed in the preceding table, no updates are required to enable
boot support.
Compatibility and installation requirements 7