FibrChanl-02 (fclp) B.11.23.1106 Fibre Channel Mass Storage Driver for HP-UX 11i v2 Release Notes

Table 4 HP-UX March 2010 (AR1003) Fixes
DescriptionDefect ID
There are no fixes for this release.N/A
Table 5 HP-UX September 2009 Fixes
DescriptionDefect ID
This fixes the issue where the fclp startup script removed the volume group directory in
/dev/fclp, followed by a number and vg name, such as /dev/fclp1dbvg03.
QXCR1000914949
Table 6 HP-UX March 2009 Fixes
DescriptionDefect ID
There are no fixes for the 0903 release.N/A
Table 7 HP-UX December 2008 Fixes
DescriptionDefect ID
The case where the fclp driver timed out on an I/O operation too soon has been fixed.QXCR1000860999
The case where the fclp driver did not recognize a single device with a loop ID of 0 on a
private loop has been fixed.
QXCR1000871619
Table 8 HP-UX September 2008 Fixes
DescriptionDefect ID
Support has been added for HP's vendor-specific implementation of SNIA APIs for the Fibre
Channel (fclp) driver.
QXCR1000749444
Table 9 HP-UX December 2007 Fixes
DescriptionDefect ID
Fixed a critical issue which occurs when using the fclp driver to perform I/O to sequential blocks
of one LUN from mulitple virtual memory address spaces, such as I/O to a swap device.
The issue caused incorrect data to be swapped in and out, which resulted in application core
dumps or kernel panics. The issue is present in FibrChanl-02 software (fclp driver) versions
SR 8606488089
B.11.23.0706 and B.11.23.0709; version B.11.23.0712 or later incorporates the fix. HP
strongly recommends that all users of fibre channel HBAs claimed by the fclp driver (AD299A
or AD355A) upgrade to version B.11.23.0712 or later.
Known problems and limitations
This section provides a list of known problems and limitations as known to HP at time of publication.
If workarounds are available, they are included.
• EFI is only bootable from the first boot entry device
This applies to the first boot entry device that is connected to an AD299A or AD355A.
Corrective action: The workaround for this issue is to re-arrange the boot list that is connected
to the adapters:
4