FibrChanl-02 (fclp) B.11.31.1009 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release

Table 10 Recommended firmware/EFI versions (September 2010)

Universal Boot CodeFirmware VersionEFI Driver VersionFibre Channel Adapter

5.03A61.00A12 or later5.03A6 or laterAH403A

5.03A61.00A12 or later5.03A6 or laterAH402A

6.03A71.10A5 or later6.03A7 or later456972-B21

N/A2.70X5 or later3.21A3 or laterAD355A, AD299A

N/A2.72A2 or later3.21A3 or laterAD221A, AD222A,

AD393A

6.00A52.72A2 or later4.00A1 or later403621-B21

For current recommended firmware versions, see the HP Fibre Channel Host Bus Adapter (fcd and

fclp) Support Matrix at http://www.hp.com/go/hpux-iocards-docs, by clicking onHP-UX 11i v3

I/O Cards .

If your Fibre Channel adapter is not listed in the preceding table, no updates are required to

enable boot support.

NOTE: Display EFI driver and ROM firmware versions using fcmsutil

<fclp_device_file> vpd

EFI/firmware bundles can be downloaded from www.hp.com, in the Software and Driver Downloads

section.

Hardware Requirements

This version of the FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v3 runs

on HP Integrity servers with the HP-UX 11i v3 (11.31) operating system. It supports Fibre Channel

hardware products such as:

• AH403A PCIe Dual Port 8Gb Fibre Channel Adapter

• AH402A PCIe Single Port 8Gb Fibre Channel Adapter

• 456972-B21 Dual Port PCIe Emulex 8 Gb Mezzanine Fibre Channel Adapter

• AD355A PCIe Dual Port 4Gb Fibre Channel Adapter

• AD299A PCIe Single Port 4Gb Fibre Channel Adapter

• AD221A HP PCIe Single Port 4Gb Fibre Channel and Single Port 1000 BT Adapter

• AD222A HP PCIe Dual Port 4Gb Fibre Channel and Dual Port 1000BT Adapter

• AD393A HP PCIe Dual Port 4Gb Fibre Channel and Dual Port 1000SX Adapter

• 403621-B21 Emulex LPe1105–HP 4Gb Fibre Channel Adapter for HP c-Class BladeSystem

NOTE: Please note the following slot limitations on rx3600 and rx6600 servers:

• Slots 5 and 6 are the recommended slots for AD221A, AD222A, and AD393A adapters.

• Slots 3 and 4 are also supported for AD221A, AD222A, and AD393A adapters, but with the

following restrictions:

I/O performance of the card may be limited.

Online Replacement is not supported.

Emulex 4Gb Fibre Channel Mezzanine (403621-B21) on HP Integrity blade servers

The Emulex LPe1105-HP 4Gb Fibre Channel Mezzanine Card for HP c-Class BladeSystem (Product

Number 403621-B21) has been shipping on HP Proliant c-Class blades for some time. The cards

have been modified to be compatible with HP Integrity c-Class blades, yet they maintain their

compatibility with Proliant c-Class blades.