FibrChanl-02 (fclp) B.11.31.1203 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

This document provides information about the B.11.31.1203 release of the FibrChanl-02 (fclp)
Fibre Channel Mass Storage Driver for HP-UX 11i v3.
FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v3
overview
This release of the document for the FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for
HP-UX 11i v3 (version B.11.31.1203) documents defect fixes and version changes.
New and changed features in this release
New features
There are no new features in this release.
Known problems fixed in this version
These issues have been fixed in the FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for
HP-UX 11i v3 March 2012 (AR1203) release. To view the entire details of the fix, refer to the HP
IT Resource Center at: http://forums1.itrc.hp.com/service/forums/home.do
Table 1 HP-UX March 2012 (AR1203) Fixes
DescriptionDefect ID
This fixes the issue where fcmsutil would incorrectly display the Previous Topology as
UNINITIALIZED when the link goes down for the first time after the system was booted or after
the driver was reloaded.
QXCR1001119607
This fixes an issue when the DLKM unload fails, the driver remains in the UNCLAIMED S/W State
while kcmodule reports that the driver is in a loaded state.
QXCR1001134094
This fixes fclputil to print correct SFP information or print appropriate error message.QXCR1001138023
This fixes a FCLP dump failure when crossing a 4GB page boundary.QXCR1001149131
Issue WARNING messages if FC Mezzanine is configured in loop.QXCR1001170935
This fixes the issue where the fclp driver may panic with “Not all objects de-allocated” when the
ESCSI controller unregistration failed because tgt paths under that controller are still registered
with SCSI.
QXCR1001156003
Table 2 HP-UX August 2011 (WEB1108) Fixes
WEB1108 release supersedes the AR1109 release.
DescriptionDefect ID
This fixes an issue where disks show up as NO_HW in the ioscan output if an unsolicited and
unsupported ELS request comes in from a known target.
QXCR1001145460
This fixes a failure case in dma mapping.QXCR1001141638
Added Fibre Channel support for the AT094A HBA.QXCR1001113883
Table 3 HP-UX September 2011 (AR1109) Fixes
DescriptionDefect ID
This fixes a hang that may occur during olrad delete.QXCR1001094158
If a zoning change or other fabric perturbation causes an fclp HBA port to permanently lose
name server visibility to all ports in the fabric while still maintaining a successful fabric login, this
change will ensure that commands to the targets through alternate paths will not be delayed.
QXCR1001067015
FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v3 overview 3