FibrChanl-02 (fclp) B.11.31.1204 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

This document provides information about the B.11.31.1204 release of the FibrChanl-02 (fclp)
Fibre Channel Mass Storage Driver for HP-UX 11i v3.
FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v3
overview
This release of the document for the FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for
HP-UX 11i v3 (version B.11.31.1204) documents defect fixes and version changes.
New and changed features in this release
New features
There are no new features in this release.
Known problems fixed in this version
These issues have been fixed in the FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for
HP-UX 11i v3 April 2012 (WEB1204) release. To view the entire details of the fix, refer to the HP
IT Resource Center at: http://forums1.itrc.hp.com/service/forums/home.do
Table 1 HP-UX April 2012 (WEB1204) Fixes
DescriptionDefect ID
This fixes a panic caused by an unsupported ELS status from the firmware. The Syslog would also
show that the driver is recovering from an unexpected condition.
QXCR1001178585
This fixes a FCLP dump write error when crossing a 4GB page boundary.QXCR1001192222
Warning message is updated for FC Mezzanine configured in Loop Topology.QXCR1001170935
This fixes a long boot time on a HPVM Guest if the Guest has a large number of stale device
special files.
QXCR1001199568
Table 2 HP-UX March 2012 (AR1203) Fixes
DescriptionDefect ID
This fixes the issue where fcmsutil would incorrectly display the Previous Topology as
UNINITIALIZED when the link goes down for the first time after the system was booted or after
the driver was reloaded.
QXCR1001119607
This fixes an issue when the DLKM unload fails, the driver remains in the UNCLAIMED S/W State
while kcmodule reports that the driver is in a loaded state.
QXCR1001134094
This fixes fclputil to print correct SFP information or print appropriate error message.QXCR1001138023
This fixes a FCLP dump failure when crossing a 4GB page boundary.QXCR1001149131
Issue WARNING messages if FC Mezzanine is configured in loop.QXCR1001170935
This fixes the issue where the fclp driver may panic with “Not all objects de-allocated” when the
ESCSI controller unregistration failed because tgt paths under that controller are still registered
with SCSI.
QXCR1001156003
FibrChanl-02 (fclp) Fibre Channel Mass Storage Driver for HP-UX 11i v3 overview 3