FibrChanl-02 (fclp) B.11.31.1209 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

Table 11 HP-UX November 2009 Fixes

DescriptionDefect ID

Some disk storage arrays, like the XP10000, might remain offline after the storage array was

reset. This problem, which only occurred in an arbitrated loop configuration, has been fixed.

QXCR1000958881

Table 12 HP-UX September 2009 Fixes

DescriptionDefect ID

There are no fixes in the 0909 release.N/A

Table 13 HP-UX June 2009 Fixes

DescriptionDefect ID

vgchange fails to activate volume groups under the fclp driverQXCR1000886720

Table 14 HP-UX March 2009 Fixes

DescriptionDefect ID

This fix delivers the concurrent dump functionality to the driver.QXCR1000772840

Table 15 HP-UX December 2008 Fixes

DescriptionDefect ID

The fix delivers the SNIA API HBA_GetFcpTargetMappingV2(), which is used to oormation about

the targets mapped through a port on a multiport Fibre Channel card.btain inf

QXCR1000867632

vPars boot panic with AD222 HBA has been fixed.QXCR1000841117

System panic due to spinlock being held too long in a tracing loop has been fixed.QXCR1000869847

The case where the fclp driver did not recognize a device with a loop ID of zero on a private

loop has been fixed.

QXCR1000886304

Table 16 HP-UX September 2008 Fixes

DescriptionDefect ID

Fixed an issue which caused system dump failure to an fclp attached device, if base page size

was set to a value other than 4 KB.

QXCR1000799018

Long hardware path from AD221A (PCIe 1 port 4Gb FC and 1 port GigE HBA) card not

recognized by vparmodify. The workaround for this issue is located at this address:http://

docs.hp.com/en/T1335-90091/ar01s05.html

QXCR1000753480

NOTE: AR0803 (Version B.11.31.0803) was the initial release of FibrChanl-02 (fclp) on HP-UX

11i v3.

Known problems and limitations

This section provides a list of known problems and limitations as known to HP at time of publication.

If workarounds are available, they are included.

• Private Loop and Public Loop topology configuration support for Fibre Channel mezzanine

adapters

Private Loop and Public Loop topology configurations are not supported for Fibre Channel

mezzanine adapters on HP Integrity Blade servers in combination with the Fibre Channel (FC)

Pass Thru I/O Interconnect modules. These configurations can result in servers losing connection