FibrChanl-02 (fclp) B.11.31.1311 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

Table 9 HP-UX March 2011 (AR1103) Fixes (continued)
DescriptionDefect ID
Corrected driver error that caused SNIA to incorrectly report the current and maximum port speed
for 8Gb HBAs.
QXCR1001054494
This corrects a problem that occurs when the fclp.pl script attempts to print some improperly
formatted trace data.
QXCR1001052221
This fixes a panic that occurs when an fcmsutil option is run at the same time that the fclp driver
is being unloaded.
QXCR1001083400
Table 10 HP-UX September 2010 (AR1009) Fixes
DescriptionDefect ID
Under rare conditions, the ioscan process can cause stack overflow panic, when there are
several targets reported offline. This problem has been corrected.
QXCR1001017932
Write operation to tape devices that encountered CRC errors can take several minutes to recover.
This problem has been corrected.
QXCR1000977659
Fixed panic due to bad kern memory access in fclp module unload with OLD events on the fclp
card.
QXCR1001019501
Renamed man page for ifc_disable_mgmt_lun to be fclp_ifc_disable_mgmt_lun.QXCR1000996401
Certain new tape drivers and virtual tape libraries can generate previously unseen FC traffic that
fclp does not handle properly, resulting in a panic with a data TLB fault. This problem has been
corrected.
QXCR1001004749
SNIA dumps core with command vxesd with fclp cards and driver.QXCR1001011407
Table 11 HP-UX March 2010 (WEB1003) Fixes
DescriptionDefect ID
Corrected a timing-related fclp driver issue that caused an inconsistent driver state. When the
driver detected this inconsistent state, it would reset the HBA unexpectedly.
QXCR1000972188
QXCR1000947409
QXCR1000980397
Modified the fclp uninitialization sequence to correct hangs that would occur during driver unload.
These hangs would only occur if I/O was in progress when the unload was initiated.
QXCR1000978071
QXCR1000946402
QXCR1000978980
QXCR1000951060
Corrected multiple issues in the fclp unload sequence that could result in unpredictable driver
unload behavior.
QXCR1000991710
Table 12 HP-UX March 2010 (AR1003) Fixes
DescriptionDefect ID
This fixes the issue where snia_demo ouputs an error message: /dev/fclp* not found,
when run on a system with the fclp driver installed and no fclp adapters connected.
QXCR1000931979
This fixes the issue where SNIA: HBA_OpenAdapter API fails with the HBA_STATUS_ERROR.QXCR1000969594
This fixes the issue where SNIA does not report more than 500 luns per HBA.QXCR1000976833
Table 13 HP-UX November 2009 Fixes
DescriptionDefect ID
Some disk storage arrays, like the XP10000, might remain offline after the storage array was
reset. This problem, which only occurred in an arbitrated loop configuration, has been fixed.
QXCR1000958881
6