FibrChanl-02 (fclp) B.11.31.1403 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

Operating system and version compatibility
The following software (or later versions) must be installed before installing the FibrChanl-02 (fclp)
driver, version B.11.31.1403, into a system:
• HP-UX 11i v3 OS Fusion version B.11.31.1103 or later
• HP-UX CommonIO B.11.31.0803 or later
• HP-UX 11.31 Support Tools Bundle, March 2008 (OnlineDiag), version B.11.31.03.06
NOTE: The FC-COMMON.FC-SNIA fileset is part of the CommonIO bundle. If
FC-COMMON.FC-SNIA (0803 or later) is not present on a system, swinstall of theFC-FCLP
product will display errors. If you ignore the errors and proceed with the swinstall, the
FC-FCLP.FC-FCLP-RUN fileset will not be installed.
This patch is required only if your system is missing the March 2008 HP-UX 11.31 Support Tools
Bundle:
• PHSS_37101 (scsi_arry patch)
Driver bundles can be downloaded from the HP Software Depot at: http://www.software.hp.com
Patches are available from either: http://www.software.hp.com or http://itresourcecenter.hp.com
OnlineDiag is available at http://www.software.hp.com in the Enhancement releases and patch
bundles section, or on the HP-UX 11i v3 OE media. Installation instructions are available at: http://
www.hp.com/go/hpux-iocards-docs, by clicking onHP Fibre Channel Host Bus Adapters.
Requirements for boot support
To boot through the fibre channel ports on these adapters, HP recommends that you update the
EFI driver and onboard firmware to the latest version. This table lists the recommended EFI and
firmware versions at the release of FibrChanl-02 (fclp) driver, version B.11.31.1403:
Table 20 Recommended firmware/EFI versions (March 2014)
Universal Boot CodeFirmware VersionEFI Driver VersionFibre Channel Adapter
5.03a152.02x2 or later4.01a5 or laterAH403A
5.03a152.02x2 or later4.01a5 or laterAH402A
6.10A02.02x2 or later4.01a5 or later456972-B21
5.03a152.82x4 or later4.01a5 or laterAD355A, AD299A
5.03a152.82x4 or later4.01a5 or laterAD221A, AD222A,
AD393A
6.10A02.82x4 or later4.01a5 or later403621-B21
5.03a152.02x2 or later4.01a5 or laterAT094A
For current recommended firmware versions, see the HP-UX Fibre Channel (fcd, fclp) and FlexFabric
FCoE (fcoc) Host Bus Adapter Support Matrix at http://www.hp.com/go/hpux-iocards-docs, by
clicking onHP Fibre Channel Host Bus Adapters.
If your Fibre Channel adapter is not listed in the preceding table, no updates are required to enable
boot support.
NOTE: Display EFI driver and ROM firmware versions using fcmsutil <fclp_device_file>
vpd
EFI/firmware bundles can be downloaded from www.hp.com, in the Software and Driver Downloads
section.
Compatibility and installation requirements 11