FibrChanl-02 (fclp) B.11.31.1403 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

Table 2 HP-UX October 2013 (WEB1310) Fixes (continued)
DescriptionDefect ID
This fixes the issue where ioscan hangs when the system is heavily loaded and the physical FC
controller port reset is run in parallel multiple times.
QXCR1001251620
This fixes the issue where sar and glance shows incorrect avque number for FCLP HBA after
channel offline.
QXCR1001254040
fclp driver is modified to report unopened targets along with successfully opened targets under
fclputil get remote all and devstat options.
QXCR1001266913
This fixes the issue where devices configured under AVIO Storage HBA for an HP-UX 11i v3
guest cannot be deleted if the guest is online.
QXCR1001275632
The fclp driver now supports up to 48 HPVM VFCs (virtual FC controllers) per one PFC (physical
FC controller).
QXCR1001278741
Table 3 HP-UX March 2013 (AR1303) Fixes
DescriptionDefect ID
This fixes a boot failure where server fails to boot with “-tm” option from a SAN device managed
by FCLP driver.
QXCR1001229789
This fixes an issue where the FCLP driver passes an incorrect N_PortID in a LOGO ELS request.QXCR1001228940
The FCLP driver is modified to split the diagnostic event#59 “Driver cannot authenticate a target
because the PWWN, the NWWN, or the nport id has changed. Luns behind this port……” into
two events for better clarity:
QXCR1001209566
• Event#59: “Driver detected an authentication failure for device id nport id, PWWN WWN.
Luns behind this port…...”
• Event#65: “Driver detected nport id change for device with PWWN WWN, old nport id
nport id, new nport id nport id”
This fixes a problem with the fclp driver where DLKM operation fails under heavy load conditions.QXCR1001205378
This fixes a problem with the fclp driver where the driver generates an insufficient firmware dump.QXCR1001217895
Table 4 HP-UX September 2012 (AR1209) Fixes
DescriptionDefect ID
Installing or updating the FCLP driver no longer requires a reboot if the driver is not in use.QXCR1001179841
This fix enables the FCLP driver to automatically probe for new target ports after the OS is booted
if target device is directly connected in a private loop topology after boot.
QXCR1001179817
This fix will allow I/O operations that have a potential duration of longer than 109 minutes (such
as some tape operations) to complete without timing out.
QXCR1001194022
Driver will no longer incorrectly print the message “fclps_els_await_res: “ to the
console/syslog.
QXCR1001196773
This fixes a timing-related issue in the FCLP driver that may cause a system panic when a driver
internal error occurs while the driver is being reset.
QXCR1001181867
This fixes a timing-related issue in the FCLP driver that may cause a system panic when a driver
internal error occurs while the driver is being reset.
QXCR1001226959
This fixes a timing-related issue in the FCLP driver that may cause a system panic when a driver
internal error occurs while the driver is being reset.
QXCR1001184198
4