FibrChanl-02 (fclp) B.11.31.1403 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

Table 5 HP-UX April 2012 (WEB1204) Fixes
DescriptionDefect ID
This fixes a panic caused by an unsupported ELS status from the firmware. The Syslog would also
show that the driver is recovering from an unexpected condition.
QXCR1001178585
This fixes a FCLP dump write error when crossing a 4GB page boundary.QXCR1001192222
Warning message is updated for FC Mezzanine configured in Loop Topology.QXCR1001170935
This fixes a long boot time on a HPVM Guest if the Guest has a large number of stale device
special files.
QXCR1001199568
Table 6 HP-UX March 2012 (AR1203) Fixes
DescriptionDefect ID
This fixes the issue where fcmsutil would incorrectly display the Previous Topology as
UNINITIALIZED when the link goes down for the first time after the system was booted or after
the driver was reloaded.
QXCR1001119607
This fixes an issue when the DLKM unload fails, the driver remains in the UNCLAIMED S/W State
while kcmodule reports that the driver is in a loaded state.
QXCR1001134094
This fixes fclputil to print correct SFP information or print appropriate error message.QXCR1001138023
This fixes a FCLP dump failure when crossing a 4GB page boundary.QXCR1001149131
Issue WARNING messages if FC Mezzanine is configured in loop.QXCR1001170935
This fixes the issue where the fclp driver may panic with “Not all objects de-allocated” when the
ESCSI controller unregistration failed because tgt paths under that controller are still registered
with SCSI.
QXCR1001156003
Table 7 HP-UX August 2011 (WEB1108) Fixes
WEB1108 release supersedes the AR1109 release.
DescriptionDefect ID
This fixes an issue where disks show up as NO_HW in the ioscan output if an unsolicited and
unsupported ELS request comes in from a known target.
QXCR1001145460
This fixes a failure case in dma mapping.QXCR1001141638
Added Fibre Channel support for the AT094A HBA.QXCR1001113883
Table 8 HP-UX September 2011 (AR1109) Fixes
DescriptionDefect ID
This fixes a hang that may occur during olrad delete.QXCR1001094158
If a zoning change or other fabric perturbation causes an fclp HBA port to permanently lose
name server visibility to all ports in the fabric while still maintaining a successful fabric login, this
change will ensure that commands to the targets through alternate paths will not be delayed.
QXCR1001067015
This corrects a potential null pointer reference and subsequent system panic during driver
initialization.
QXCR1001097754
This change will log an Event Monitoring Service (EMS) event and syslog information whenever
a Fibre device comes back in the Name Server.
QXCR1001094073
This fixes the issue where the fclp driver may panic with “Bad News!” when an fcmsutil command
is run at the same time that the fclp driver is being reset.
QXCR1001123527
This fixes the issue where the fclp driver may panic with “Not all objects de-allocated" during
FibrChanl-02 depot installation or during DLKM unload operation.
QXCR1001124463
Known problems fixed in this version 5