FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes Version Number B.11.31.1103.01 HP Part Number: 5900-1172 Published: April 2011 Edition: 1.
Contents FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 overview............................3 New and changed features in this release...................................................................................3 New features......................................................................................................................3 Known problems fixed in this version...........................................................................................
This document provides information about the B.11.31.1103.01 release of the FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3. FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 overview This release of the document for the FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 (version B.11.31.1103.01) documents the initial release of the FibrChanl-03 (fcoc) bundle with full functionality.
• The HP-UX boot path is lost during un-assign and re-assign of the BL8x0C i2 (Blade) profile. The scenario that leads to this is: 1. Create a profile and assign it to the blade. Install a SAN disk connected from HBA with HP-UX on it. 2. Power off the blade. 3. Un-assign the profile from the blade. 4. Power on the blade to EFI shell (bare-metal state). 5. Power off the blade. 6. Re-assign the profile back to the same blade. 7. Power on the blade again.
4. A list of all the adapters in the system is displayed. Your list may vary depending on the installed adapters. Locate the adapter you want to configure. Use the up/down arrows on your keyboard to select it, and press Enter. 5. The Emulex Adapter Configuration Main Menu screen comes up. Select Set Boot From SAN. A Disable Enable menu is displayed. Use the arrow keys to select the Enable option and press Enter. The selection is updated to NVRAM and the current setting is displayed.
. 7. 8. On the same Emulex Adapter Configuration Main Menu screen, select Back to Display Adapters and RECONNECT DEVICES and press Enter. Type s to save the changes. Exit the Emulex utility. Control B to go into cm and type rs to reset the system. Compatibility and installation requirements This section describes the compatibility information and installation requirements for this release. For specific installation instructions, refer to the installation guide specific to your FibreChannel card.
NOTE: The FC-COMMON.FC-SNIA fileset is part of the CommonIO bundle. If FC-COMMON.FC-SNIA (1103 or later) is not present on a system, swinstall of the FC-FCOC product will display errors. If you ignore the errors and proceed with the swinstall, the FC-FCOC.FC-FCOC-RUN fileset will not be installed. Hardware Requirements This version of the FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 runs on HP Integrity BL8x0c i2 servers with the HP-UX 11i v3 (B.11.31) operating system.
