FibrChanl-03 (fcoc) B.11.31.1103.01 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes

6. On the same Emulex Adapter Configuration Main Menu screen, select Back to Display
Adapters and RECONNECT DEVICES and press Enter.
7. Type s to save the changes.
8. Exit the Emulex utility. Control B to go into cm and type rs to reset the system.
Compatibility and installation requirements
This section describes the compatibility information and installation requirements for this release.
For specific installation instructions, refer to the installation guide specific to your FibreChannel
card.
Operating system and version compatibility
The March 2011 update of HP-UX 11i v3 (B.11.31.1103) must be installed for all supported
Emulex-based Fibre Channel cards.
The following software (or later versions) must be installed before installing the FibrChanl-03 (fcoc)
driver, version B.11.31.1103.01, into a system:
• BL8x0c i2 System Firmware 15.05 or higher
• C7000 OA Firmware 3.20 or higher
• VCSU FW 1.6.0 or higher
• VC-Enet FW Version 3.15 or higher (for profile migration, 3.17 or higher is required)
• Everready Firmware version 2.702.485.4 or higher
• HP-UX OS Fusion version 1103 or higher
• HP-UX CommonIO 11.31.1103 (B.11.31.1103) or higher
6