FibrChanl-03 (fcoc) B.11.31.1303 Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes
Table Of Contents
- FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 Release Notes
- Contents
- FibrChanl-03 (fcoc) Fibre Channel Mass Storage Driver for HP-UX 11i v3 overview
- New and changed features in this release
- Known problems fixed in this version
- Known problems and limitations
- Compatibility and installation requirements
- Related information
- Software availability in native languages
5. The Emulex Adapter Configuration Main Menu screen comes up. Select Set Boot From
SAN. A Disable Enable menu is displayed. Use the arrow keys to select the Enable option
and press Enter. The selection is updated to NVRAM and the current setting is displayed.
6. On the same Emulex Adapter Configuration Main Menu screen, select Back to Display
Adapters and RECONNECT DEVICES and press Enter.
7. Type s to save the changes.
8. Exit the Emulex utility. Control B to go into cm and type rs to reset the system.
Compatibility and installation requirements
This section describes the compatibility information and installation requirements for this release.
For specific installation instructions, refer to the installation guide specific to your FibreChannel
card.
Operating system and version compatibility
The following software (or later versions) must be installed before installing the FibrChanl-03 (fcoc)
driver, version B.11.31.1303, into a system:
• BL8x0c i2 System Firmware 15.05 or higher
• Superdome2 System Firmware 2.26 or higher
8